Tuberculosis secondary prevention
|
Tuberculosis Microchapters |
|
Diagnosis |
|---|
|
Treatment |
|
Case Studies |
|
Tuberculosis secondary prevention On the Web |
|
American Roentgen Ray Society Images of Tuberculosis secondary prevention |
|
Risk calculators and risk factors for Tuberculosis secondary prevention |
Editor-In-Chief: C. Michael Gibson, M.S., M.D. [1]
Secondary Prevention
Implementing a Respiratory Protection Program
The health-care setting should develop a policy on the use of respirators by visitors. Visitors to AII rooms and other areas with patients who have suspected or confirmed infectious TB disease may be offered respirators (e.g., N95 disposable respirators) and should be instructed by an HCW on the use of the respirator before entering an AII room.
To be effective and reliable, respiratory protection programs must include at least the following elements:
- Assignment of responsibility to one person with sufficient knowledge who is given the authority and responsibility to manage all aspects of the program.
- Standard operating procedures that include information and guidance for the proper selection, use, and care of respirators.
- Screening by a physician or other licensed health-care professional of all HCWs who might need to use a respirator for pertinent medical conditions at the time they are hired, and then re-screening periodically.
- Annual training of HCWs with specific focus on prevention, transmission, and symptoms.
- Selection of filtering facepiece respirators approved by CDC/NIOSH.
- Fit testing performed during the initial respiratory protection program training and periodically thereafter, in accordance with federal, state, and local regulations.
- Inspection and maintenance of respirators according to manufacturer instructions.
- Evaluation of the respirator program periodically to ensure its continued effectiveness.
- Information on the development and management of a respiratory protection program is available in technical training courses that cover the basics of respiratory protection. Such courses are offered by OSHA, the American Industrial Hygiene Association, the American Conference of Governmental Industrial Hygienists, universities, manufacturers, and private contractors
TB Infection-Control Measures
The TB infection-control program should be based on a three-level hierarchy of control measures. The first and most important level of the hierarchy, administrative measures, affects the largest number of persons and is intended primarily to reduce the risk of uninfected persons exposed to persons who have TB disease. These measures include the following activities:
- Assigning responsibility for TB infection control in the setting.
- Conducting a TB risk assessment of the setting.
- Developing and instituting a written TB infection-control plan to ensure prompt detection, airborne precautions, and treatment of persons who have suspected or confirmed TB disease.
- Ensuring the timely availability of recommended laboratory processing, testing, and reporting of results to the ordering physician.
- Implementing effective work practices for the management of patients with suspected or confirmed TB disease.
- Ensuring proper cleaning and sterilization or disinfection of potentially contaminated equipment (e.g., bronchoscopes, endoscopes).
- Training and educating health-care workers (HCWs) regarding TB, with specific focus on prevention, transmission, and symptoms.
- Screening and evaluating HCWs who are at risk for TB disease or who might be exposed to M. tuberculosi.
- Applying epidemiologic-based prevention principles, including the use of setting-related infection-control data.
- Using appropriate signage advising respiratory hygiene and cough etiquette.
- Coordinating efforts with the local or state health department.
The second level of the hierarchy is the use of environmental controls to prevent the spread and reduce the concentration of infectious droplet nuclei in ambient air. Primary environmental controls control the source of infection by using local exhaust ventilation (hoods, tents, or booths) and dilute and remove contaminated air by using general ventilation. Secondary environmental controls control the airflow to prevent contamination of air in areas adjacent to the source (airborne infection isolation [AII] rooms) and clean the air by using high efficiency particulate air (HEPA) filtration, or ultraviolet germicidal irradiation.
The first two control levels of the hierarchy minimize the number of areas in the health-care setting where exposure to M. tuberculosis may occur.
They reduce, but do not eliminate, the risk in those few areas where exposure to M. tuberculosis can still occur (e.g., AII rooms housing TB patients and treatment rooms in which cough-inducing or aerosol-generating procedures are performed on TB patients). Therefore, the third level of the hierarchy is the use of respiratory protective equipment in situations that pose a high risk of exposure to M. tuberculosis.
Use of respiratory protection equipment can further reduce risk for exposure of HCWs to infectious droplet nuclei that have been expelled into the air from a patient with infectious TB disease. The following measures can be taken to reduce the risk for exposure:
- Implementing a respiratory protection program
- Training HCWs on respiratory protection
- Training patients on respiratory hygiene and cough etiquette procedures.
- Determining the Infectiousness of TB Patients
- In general, patients who have suspected or confirmed TB disease should be considered infectious if (a) they are coughing, undergoing cough-inducing procedures, or have positive sputum smear results for acid-fast bacilli (AFB); and (b) they are not receiving adequate antituberculosis therapy, have just started therapy, or have a poor clinical or bacteriologic response to therapy.
For patients placed under airborne precautions because of suspected infectious TB disease of the lungs, airway, or larynx, airborne precautions can be discontinued when infectious TB disease is considered unlikely and either
- Another diagnosis is made that explains the clinical syndrome, or
- The patient produces three consecutive negative sputum smears collected in 8- to 24-hour intervals (one should be an early morning specimen).
Patients for whom the suspicion of infectious TB disease remains after the collection of three negative sputum smear results should not be released from airborne precautions until they:
- Receive standard multidrug antituberculosis treatment (minimum of 2 weeks) and
- Demonstrate clinical improvement.
For these patients, additional diagnostic approaches (e.g., sputum induction) and, after sufficient time on treatment, bronchoscopy may need to be considered.
Patients who have drug-susceptible TB of the lung, airway, or larynx, should remain under airborne precautions until they:
- Produce three consecutive negative sputum smears collected in 8- to 24-hour intervals (one should be an early morning specimen).
- Receive standard multidrug antituberculosis treatment (minimum of 2 weeks).
- Demonstrate clinical improvement.